Scuff for paint. Once your Mustang is totally stripped of exterior chrome it's time to scuff up the existing paint. The paint shop should do this also, but on the lower end paint packages they won't spend much time here. It's better for you to do it so you know it's done thoroughly. Semi-gloss paints are very similar to gloss plaints except it has lesser sheen. Semi-gloss is also suitable for rooms with high humidity (best used for children's room) and can be used for trim works and casings. These paints ensure maximum durability. The lite version of Galkyd is simply thinner. I use it more than the other. I love it. Paintings I did 16 years ago using Galkyds look as pristine as the day I painted them. You'll also need a canvas and some paint. I buy a tube of red, green, blue, purple, yellow, brown, white and black. I prefer what's called Ivory Black and a soft mixing white as you'll add white to a lot of different colors to make lighter versions. From these basic colors you can make any exotic color by mixing them in combination's. Be creative and experiment. And don't be afraid of color, because color is the most popular in museums! The bright paintings are historically the crowd favorites. As for color variety from these basic colors, mix red and white to make pink, mix yellow with green to make lime green, white with blue to make light blue, white with black to make gray, etc. Use your common sense and play with it! You'll also need pencils, an eraser and some Turpentine or Turpentine substitute. Keep your brushes soaking in it in a plastic cup to keep them clean and ready for your next color choice.... and to keep them from drying out.
Better still, you don't have to spend hours getting ready and hours cleaning up afterward. Premixed paints, electric-drill attachments and self-dispensing calking guns make short work of preparation. Cleaning up is a soap-and-water job for the rubber paints, or a quick dip in special cleaners for the oils. Disposable dropcloths and paper paint pails are used once and thrown away. Satin or silk - Water-based vinyl or acrylic paint for walls in high-wear areas, such as hallways and kitchens. A satin finish will be slightly shinier than silk. Since the trim is the first to go, the main body of the home will be shortly behind requiring painting. If the trim was recently painted, and a few years later the body is ready for paint, all the trim will need to be covered, commonly referred to as masking off. Masking off expends time, labor and material, which adds to the bottom line cost to the remaining 40%, typically costing an additional 25% for masking trim. Thus costing 25% more after both trim and body portions are painted in separate years. Flat paints (matte paints) are non-reflective and always a good choice for large walls and ceilings. Flat paints hides imperfections on wall surfaces and spatters well during application. Flat paints are the best choice for vinyl and aluminum siding that is scratched or dented because it hides imperfections and spatters less when applied. These paints are ideal for low-traffic areas such as formal dining rooms and master bedrooms.