Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel.
Rubber-base paints, which dry to a hard semi-gloss finish, may be used on concrete floors below grade, providing the floor is not continually damp from seepage and condensation.
What colors are prevailing - tonal or local, warm or cold?
Matt - Describes paints that give a flat, non-reflective finish. It is ideal for walls and ceilings that are not perfectly smooth.
Semi-gloss paints are very similar to gloss plaints except it has lesser sheen. Semi-gloss is also suitable for rooms with high humidity (best used for children's room) and can be used for trim works and casings. These paints ensure maximum durability.
Suppose it rains while you're working? Vinyl paint dries fast - as quickly as 10 to 30 minutes - and will withstand a shower after that time. It takes another 12 hours to "cure," by then forming an exceptionally tough, long-lasting film that stands up well against weather, sun, salt air and factory smoke.
The principal ingredient in whitewash is lime paste. A satisfactory paste can be made with hydrated lime, but better results are obtained by using quicklime paste that has been slaked with enough water to make it moderately stiff. The lime paste should be kept in a loosely covered container for at least several days. Eight gallons of stiff lime paste can be made by slaking 25 lbs. of quicklime in 10 gallons of water, or by soaking 50 lbs. of hydrated lime in 6 gallons of water. After soaking, the paste should be strained through a fine screen to remove lumps or foreign matter.