Stripping all the chrome. One of the single most important steps in saving money on a paint job is to strip your Mustang as much as possible yourself. This means taking off anything and everything that won't be painted. The more you take off the less the painter has to mask around. Masking not only takes their time (which costs you money) but it also results in areas that simply can't get a full coat of paint. If you take everything off, then the painters can simply scuff and spray, which will give you better and more consistent coverage. Also, when checking the paint, be realistic and don't ignore areas just for the sake of convenience. It will cost you more in time and money later. Typically if one area of the paint is cracked or peeling, then the paint on the entire car is suspect. Maybe the rest of the car just hasn't quite reached that point of decay, but it will shortly. So if you only fix areas that look bad, you'll likely find that you wasted a paint job when the other areas start to crack or peel in a year or two. The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it.
A Gloss paint is easy to clean and resists scuffs better. This is ideal for rooms that are constantly used. Most gloss paints are best recommended to use on woodworks, baseboards, kitchen and bathroom walls, doorjambs, and window casings. The downside of using gloss paints, however, is the noticeable imperfections in the wall surface. When you plan with split complementary colors, you begin with a single reference color. Next, choose a color from either edge of the complementary color and use it. While the complementary color scheme is a little more obvious, this scheme can fail totally if you just use paler versions of your warm colors. By the same token, picking a a warm undertone for the main contrasting color and combining it with two cool tones will showcase the warm tone. If new caulk is applied, main body portion needs to be touched up, and most of the time new paint will not match aged paint even using exactly the same paint out of the same paint can, as sheen difference will come into play. Interior paints are used to obtain pleasing decorative effects, improve sanitary conditions, and insure better lighting. These paints may be divided into four types: wall primers; one-coat flats; flat, semigloss, and gloss; and water paints.