Rubber-base paints, which dry to a hard semi-gloss finish, may be used on concrete floors below grade, providing the floor is not continually damp from seepage and condensation. Composition Wallboard. Composition wallboard usually presents no particular painting difficulties if the ordinary precautions are observed, such as making certain that the surface is dry and free from grease and oil. The painting procedure for wallboard is the same as for plaster; it requires a priming and sealing coat followed by whatever finishes coats are desired, or may be given one-coat flat or resin-emulsion type paint. Amateur house painters never had as much help as today. Scores of new paints and equipment placed on the market in the last few years make it possible for the weekend handyman to paint his own house almost as easily as a professional. From one-coat paints to disposable blowtorches, everything has been designed to make the job go faster, look better and cost less.
Painting trim is normally done by roller and brush, not sprayed, so more manual labor is required painting trim, and most cases costing 60% of the total exterior painting job. Solvent or oil-based paints are used where a tough, durable finish is required for interior and exterior timber, masonry and furniture - although, as mentioned above, the new generation of acrylics and multi-surface paints offers viable alternatives. In general, brushes need to be cleaned with turpentine or white spirit. To design a look with analogous colors, you can have any three colors next to each other on the color wheel. Successfully combining these colors in a room is one of the easiest, next to using monochromatic colors. In general you will want your design to use similar tones throughout the room except in the case of accent colors, which may be bolder. Materials and their application, every paint manufacturers paint will vary. If you are freshening up old walls and painting back to the existing color, the product doesn't have to be high end or have good coverage. If you need to paint a dark color over light color or light color over dark, you may want to consider purchasing a top quality paint to avoid multiple coats. I suggest Valspar, Pittsburgh or Benjamin Moore top of the line wall paint. These brands work well for straight out of the bucket use and are application friendly. Sherwin Williams is not my first choice because the coverage is poor and you will have to apply multiple coats but, it does apply, fluently. If you find a product does not apply well, maybe it is to heavy and/or sagging on the wall, you may need to thin the paint with a little water, this will reduce the coverage but make the paint flow better and lay down nicer on the surface. I do recommend latex paints for all applications, these days a good high end latex is as good as oil paint and your tools clean up much easier, it will also be less harsh on the respiratory system. The only situation I recommend oil paint, is as a primer/stain blocker over stains that "bleed" through the paint. You can get a stain blocking oil primer in a convenient spray can and spot prime any trouble areas before painting and in the case you need to prime all of the wall due to smoke or water damage, I recommend getting it in gallons and rolling it on where the stains are present. Don't forget proper ventilation and/or a respirator when using the oil based primers!