Primer paints may be oil- or water-based and are used to seal unpainted surfaces to prevent covering coats of paint soaking in. The appropriate type of primer should be used for the surface being painted - wood, metal, plaster or tiles. There are some 'all purpose primers' available which are designed for two or more of these surfaces. Will the color look harsh on me? If you choose a hair color that is natural looking, it will not look harsh on you. For example: If you are young, and want to enhance your own hair color. Your stylist will choose a color very similar to what you already have. Younger people can get away with more drastic changes in their hair color because they generally have vibrant skin tones. Although, if a young person chooses a black color for instance, and their hair color is not naturally black, this can sometimes be very harsh looking on them also. Like wise, when young people with very dark hair, try to go all over blonde, it can be a too harsh for the same reasons. To balance color, you must grasp the interconnectedness of color schemes. All color interactions are defined in the color wheel, and it has been used to build color schemes for centuries.
Selecting a Shop. You should always get quotes from at least 2-3 different shops near you. This will give you a chance to not only compare prices, but to also check out the quality of work each shop has done. Ask to see cars they've just painted. Look for orange peel or excessive overspray. Do they mostly do insurance work or do they paint entire cars also? What types of cars are they working on? A shop that sprays nothing but old beaters probably doesn't inspire as much confidence as one that does insurance work for the local Lexus or Mercedes dealer. Concrete Floors. Two general types of paints for concrete floors are varnish and rubber-base paint. Each has its limitations and the finish cannot be patched without the patched area showing through. Floor and deck enamel of the varnish type gives good service on concrete floors above grade where there is no moisture present. The area covered by a gallon of whitewash depends upon the nature of the surface, but ordinarily a gallon will cover about 225 sq. ft. on wood, about 180 sq. ft. on brick, and about 270 sq. ft. on plaster. The formulas mentioned will make from 10 to 14 gallons of whitewash. If a smaller quantity is desired, the amount of each ingredient should be reduced proportionately. There are two bases of paint for your house: solvent-based (oil or alkyd) and water-based (latex). Oil-based paints dry slow - usually taking up to 24 hours. The best clean up for an oil-based paint is turpentine or paint thinner. Latex paints' advantage is that it dries relatively fast, but it is not desirable in hot weather or direct sunshine. The best clean up for latex paints requires just soap and water. So if you are painting the inside of your house, it is recommended to use water-based paints, while solvent-based paints are suggested for painting the exterior of your house.