Paint should not be applied to a concrete basement floor until the concrete has aged for at least a year. The floor should be dry when painted, the best time for application being during the winter or early spring (assuming there is some heating apparatus in the basement), when the humidity in the basement is low. In general, three coats of paint are required on an unpainted floor, and the first coat should be thin to secure good penetration. After the paint is dry, it should be protected with a coat of floor wax. Most of us look to save where we can, especially in this day and economic conditions. House painting is no different, when it comes to saving money. A home exterior weathers from harsh elements of heat, cold, sun, and snow, and exterior paint ages over time needing repainting. Exterior trim, being that of solid wood is normally the first to show signs of painting maintenance. Many times a homeowner happens to call, asking for only painting the trim. Trim paint jobs sound good at first, but have some underlying thoughts may have not been considered. Below are things to consider when considering painting trim only. Building a monochromatic theme simply uses a single color in graduating shades like cream, beige and brown. It is hard to go wrong with this color palette, so everyone can use it successfully. But unless variations of the one color used are handled with flair, this can be an unexciting look.
Changing Colors. If you're keeping your Mustang the same color it is now then things stay pretty simple. Areas like the door jambs and inside of the trunk are probably still in good shape since they aren't exposed to the weather and you won't have to worry about repainting them. But if you're changing colors these extra areas will cost you. Be sure the price quote you get from the paint shop includes these extra areas. If you wait until the day you pull up with your Mustang prepped for paint you could be surprised by this extra cost. Limewash - Made from slaked lime and water, this paint is good for porous surfaces such as brickwork, render and plaster and gives a chalky finish. It is available from specialist companies. Some manufacturers recommend their vinyl paints for interior as well as exterior use; others say no, not so good. There are vinyls made specifically for interiors. Our next step is mixing the oil paint. DO NOT SKIP THIS STEP. Obviously you will need to buy some paint thinner, but the most important product you will need is Penetrol $12. Take a plastic quart cup that you will be painting out of and fill it up about three quarters with paint. Now mix in a couple of tablespoons of Penetrol and the slightest amount of thinner. Mix it up with a stick real good and you are ready to go. Why Penetrol? This product is the key to a fantastic looking job. Penetrol will not only smooth out the finish it will extend the time (usually about 20 minutes) before the paint starts to get sticky. This will allow you to apply a glass like finish and eliminate brush marks. We are going to apply two coats here as well so don't glob on the paint. When you are painting the door frames get used to the paint and watch your drips. After about ten minutes or so you will get used to how the paint flows and how damn good your finish looks. Allow to dry overnight before apply second coat. Tip: after you apply the second coat remove the tape and don't allow to dry first. You will get a little paint on your hands from the tape, but deal with it. By removing the tape now you will ensure crisp lines. In some case when you allow the second coat to dry you will pull a bit of the oil paint off. It is not common, but in my opinion why take the chance.