When spraying your house, it is a good rule of thumb to spray in the direction of the grain of the material. So if you have siding that runs horizontal, you want to spray in a horizontal style. Also, when you go to spray, the gun should be approximately 12" from the material that you are spraying. Do not pull the handle to spray with your hand still. This will spray a lot of paint in one spot causing it to drip. So have your hand moving when you go to depress the handle. This will give you an even look to your paint.
Matt - Describes paints that give a flat, non-reflective finish. It is ideal for walls and ceilings that are not perfectly smooth.
THE COMPOSITION. Now go back to the subject and your first impressions about the painting. It's time to analyze how the artist made you feel the way you felt using the artistic means it his/her disposal. The composition is the position and the balance of the objects and figures in the space, the interrelation of their size, coloring, shading etc. How exactly does all that impact your perception? Let's dig in.
You can use vinyl on almost any exterior except previously painted wood. It works fine on wood shingles and shakes, asbestos shingles, brick, stucco, concrete and masonry blocks. One manufacturer says you can even put it on wood clapboard if the clapboard is new and unprimed.
Valspar Paint, for instance, also produces paint branded as Laura Ashley, Eddie Bauer, Waverly, and more. These separate lines, or collections, have their own color wheel displays and are usually available wherever the primary brand, Valspar in this case, are sold. Other examples are Disney Paints, currently produced by Behr, and Ralph Lauren and Martha Stewart, formerly produced by Sherwin Williams.
Following a European directive, the British paint industry has reduced VOCs in two stages, the second of which came into force in January last year.
Proper brush technique: When "cutting in" with a paint brush you should dip the brush in paint and tap the sides of the bucket on each side of the brush, leaving a good amount on the brush so you are able to minimize the times you will need to dip/load the brush. Next, take the brush and make a one foot to two foot line down the wall about an inch or two away from the trim or surface you are going to paint up next to, this is much like taking a knife full of butter and spreading it across an entire slice of bread. After, spreading the paint over the section, go back and even the paint out evenly across the section and cut up next to the trim with the brush. You want to paint up next to the trim or surfaced to be cut-in with the paint brush after you have released most of the paint on the wall, it is easier to cut in with the tips of the brush exposed and not loaded with a lot of paint.