Red color belongs to the three main colors (together with blue and yellow). This color has a lot of shades from light pink to reddish brown. Red is an ideal irritant, there is a reason it is used in corrida to irritate the fighting bulls. You can use vinyl on almost any exterior except previously painted wood. It works fine on wood shingles and shakes, asbestos shingles, brick, stucco, concrete and masonry blocks. One manufacturer says you can even put it on wood clapboard if the clapboard is new and unprimed. The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it.
Following a European directive, the British paint industry has reduced VOCs in two stages, the second of which came into force in January last year. You can tell when the bucket of paint is getting low when the airless starts pumping really loud and doesn't stop. Simply tip the nearly empty bucket of paint, at an angle so that the mesh filter is covered and wait for the airless to catch up and stop pumping. Sometimes it's just easier to just to replace the bucket of paint with the new one and when that starts going down, pour the excess from the old bucket into the new one. Try before you buy Colour cards are fine for making an initial selection but you will want to see a true paint sample in situ before committing. Tester pots vary in price from £1 to £4. Paint onto a sheet of paper that you can move around the room to enable you to see the colour in different light conditions. The effect varies greatly. The window wall can seem dark while the wall opposite will be flooded with light. And of course there is a dramatic difference between natural and artificial light. Finally paint a patch directly onto the wall to gauge the colour, coverage and the final finish. Use Plain White Primer for Light Paint Colors. In our first case, if you decide to paint a wall in your house with a light yellow color, but the wall is currently a deep dark brown, you will go through bucket after bucket of paint trying to cover that brown, easily doing 4 - 6 coats or more. But if you put down a coat of white primer first, you could be done after 2 coats of paint.