If you are grappling with the problem of choosing a woodwork colour to go with neutral walls, check out Architectural Colours by David Oliver, the founder of Paint & Paper Library. He arranged his off-whites for ceilings, cornices, walls and woodwork in chromatical groups and the concept has been so well received that chromatically arranged colours, such as soft greys, greens and pinks, have been introduced. Also, when checking the paint, be realistic and don't ignore areas just for the sake of convenience. It will cost you more in time and money later. Typically if one area of the paint is cracked or peeling, then the paint on the entire car is suspect. Maybe the rest of the car just hasn't quite reached that point of decay, but it will shortly. So if you only fix areas that look bad, you'll likely find that you wasted a paint job when the other areas start to crack or peel in a year or two. Fine motor: Beginning to learn to use a pencil before you have developed finger and thumb strength and stability results in a child developing an inefficient pencil grip. When a child has weak thumb stabilisers, he is likely to wrap his thumb around his index finger to try to create greater stability. This makes it very difficult for him to then develop the necessary finger isolation (separate movement of the fingers to give easy, dextrous pencil control). Children who have not yet developed their wrist stability will try to use whole-arm movements to do their drawings and writing and will press very hard. If a child has not developed the bilateral integration (this happens in the brain and is the smooth, efficient communication of the right side of the brain with the left) cutting will be difficult and he will have difficulty writing across his page and reading across a page or school board. Beginning to use a pencil too soon therefore inhibits learning in a formal class setting, rather than helping it.
Better still, you don't have to spend hours getting ready and hours cleaning up afterward. Premixed paints, electric-drill attachments and self-dispensing calking guns make short work of preparation. Cleaning up is a soap-and-water job for the rubber paints, or a quick dip in special cleaners for the oils. Disposable dropcloths and paper paint pails are used once and thrown away. Always use a sanding block for flat surfaces. Just your hand behind a thin piece of sand paper can leave grooves and low spots. It's also easier on your hands. For inside curves try wrapping the sand paper around a short section of garden or heater hose. This will help approximate the concave curve and help stay away from sanding through hard edges. On hard edges, like the top ridge of a fender or leading edge of a hood, you need to do this by hand. A sanding block will quickly dig right through the paint on a hard edge and take you down to bare metal. This means primer and more sanding. If a desired shade is not obtainable in custom-or ready-mixed paints, white paints may be tinted with colors-in-oil. To do this, mix the color-in-oil with a small amount of turpentine or mineral spirits and stir this into the white paint, a little at a time. If a blended color is desired, more than one color may be added, such as a chrome green and chrome yellow pigments to produce a lettuce green shade. Satin paints offer a good combination of easy-clean and moderate sheen. These paints go a step above eggshell in scrubbing ability. They perform and look great in just about any room.