Preparation, the key to a successful paint job is to take the correct steps when preparing the job. Preparation for this article, has two parts, the first part is wall prep. The walls you are going to paint may have nail holes or imperfections that need to be filled before you paint. The proper way to fill them, if they are smaller is with water putty, by simply forcing a little bit of the putty in the hole and breaking it off flush with the surface. For larger depressions, use a drywall compound or spackle, which may require a second application to fully fill the indentation and make the repair/"patch" flush with the wall. Painting trim is normally done by roller and brush, not sprayed, so more manual labor is required painting trim, and most cases costing 60% of the total exterior painting job. Once the drywall compound/spackle has had sufficient time to dry, you will need to lightly sand the surface of the repair to smooth out any ridges that may have been caused while "coating" the patch. Once you have the surface sanded smooth, take a wet sponge or cloth and, by lightly washing/rubbing, blend the outside edge of the drywall compound/spackle back into the wall. For a smaller repair, you can wash away the excess drywall compound, leaving only the compound/spackle only in the area where the indent was filled. For a larger hole, after filling, sanding and using a wet sponge to blend the outside edge of the compound back into the wall, it may be necessary to texture the area in order to give the smooth patch the appearance of the existing wall.
Step three: go online and study the basics of shadow and light. It's a visual thing, and too complicated to talk about here. But once you see it, it'll come to you quickly. Simply Google "shadow and light in painting" and the basics will come up. Once you know these rules, you can apply it to any shape, any form, any painting. And it'll make you keenly aware of shadow and light on virtually any object on earth. It's what makes a painting three- dimensional and expensive looking. You can also buy art books on shadow and light at any bookstore. But make sure you sit down for a couple of hours and study it. It will come quickly to you, I promise. When all of the spraying is complete, its time to remove all masking tape and paper and start touching up your entire home. This step is pretty time consuming because this is the final stage that really makes your home look good. The more time you spend here, the better your home will look. You can tell when the bucket of paint is getting low when the airless starts pumping really loud and doesn't stop. Simply tip the nearly empty bucket of paint, at an angle so that the mesh filter is covered and wait for the airless to catch up and stop pumping. Sometimes it's just easier to just to replace the bucket of paint with the new one and when that starts going down, pour the excess from the old bucket into the new one. Will the color fade? Now this is a very broad question with various answers. Hair color fading is due to many factors. First of which is, the ability of the hair to hold hair color. We call this porosity. If the hair is overly porous it will have a problem holding hair color. There are ways a stylist can usually alleviate this problem. Once in a while the hair is so damaged it absolutely impossible for the hair to hold color. Your stylist should always have the skills to evaluate these situations, and recommend certain conditioning treatments to bring the hair back to a normal porosity.