Masonry Walls and Ceilings. Interior masonry walls and ceilings above grade may, in general, be painted in much the same manner as plaster surfaces. Here again, it is necessary to allow adequate time for the masonry to dry before applying paint and, in addition, attention should be given to the preparation of the surface. When decorating a wall containing Portland cement (concrete, for example), it is essential to take precautions against the attack of alkali. For this purpose, alkali-resistant primers such as rubber-base paints may be used when oil paints are to follow. Obviously, when mistakes like this occur paint companies have nothing to lose. Whenever people pick paint colors that they are unhappy with, the paint company does not have to refund the customers' money. In fact, no paint brand in the country will allow you to return paint once you have purchased it. Even better (for the paint company), since the customer is unhappy with the paint color they chose, they are probably just going to buy a whole new batch of paints! Knock down texture is basically a orange peel that is sprayed on and allowed to "set-up" for a minute or two then gently "knocked down" by running a 6" drywall knife over it, "knocking down" the surface of the texture. Although knock down is a flattened version of orange peel, I suggest you do not use a spray can of orange peel, the knock down comes in its own spray can and the results are much better, again experiment before spraying it on the wall. However, If ever you apply any of the textures to the wall and are not satisfied with the results, wash the texture off immediately before it dries, then allow the wall to dry and try it again. Once you have the texture applied to your liking and you have allowed it to dry, you may want to paint the patches a couple of time before painting the entire wall, especially for walls where the paint to be applied will have some sheen. Multiple coats on these areas will make them blend in, unnoticeable, with the rest of the wall. You will know if the patches need more coats of paint, because the patch/texture will have absorbed the paint causing the spot to look duller than the rest of the existing wall.
Once you figure out which position is prime and which position is spray, place the valve in the prime position and grab the primer hose. Point the primer hose in the empty bucket near the top and at an aproxx.45 degree angle from the side (the reason for this is that there is likely to be pressure still built up in the airless and when you first switch on the airless to prime it, paint will likely burst out of the primer hose and you don't want to have it go everywhere). Now turn the airless paint sprayer on and you will see that the airless is sucking up the new paint and pumping out the primer hose. At first you will typically see a cleaning solution come out followed by your paint. When you see your paint coming out switch over the primer valve to the other position and you will see the airless pumping paint into the main hose. The most flattering eye shadows are green blue, blue grays and lavender. The best eye pencils colors are in medium blues and charcoal. Lipstick and blush colors should be in rose, pink or plum colors. Let you lashes appear longer and fuller with navy or charcoal mascara. A flat, semi-gloss, or high-gloss finish may be applied to the primed surface. For a flat finish, two coats of flat wall paint should follow the priming coat. For a semi-gloss finish, one coat of flat wall paint and one coat of semi-gloss paint should be applied to the primed surface. For a high-gloss finish, one coat of semi-gloss paint and one coat of high-gloss enamel should be used over the priming coat. Treat yourself to a good lunch and forget the diet. It is amazing what some pizza or a good burger will do for the afternoon painting push.