Saved and The Distinguished Member of the Humane Society. Sir Edwin Henry Landseer, best known for his lion sculptures in Trafalgar Square, London, created a dog painting called Saved in 1856 which depicts a Newfoundland dog saving a small child from drowning. Eighteen years previous to that he had used the same dog breed for his now famous The Distinguished Member of the Humane Society. Each of the dogs portrayed, which may actually be two images of the same animal, are of the black and white variety of Newfoundland not particularly common at the time. His obvious love for this particular breed made Landseer famous with dog kennels and shows around the world. The Landseer Newfoundland is named after him.
Jodhpur School: The centre of this hand made paintings are love scenes then the other art figures. The Jodhpur School of Miniature paintings depict love scenes of lovers Dhola and Maru on camel back. There are hunting scenes with elephants and horses. The major colors used in this style of painting are gold and stone color.
EXTERIOR PAINTING. In buying paints that you are going to use for your exterior house, you have to pick a brand that has essential characteristics: hiding power, color retention, chalk-resistance, and blister resistance.
Proper brush technique: When "cutting in" with a paint brush you should dip the brush in paint and tap the sides of the bucket on each side of the brush, leaving a good amount on the brush so you are able to minimize the times you will need to dip/load the brush. Next, take the brush and make a one foot to two foot line down the wall about an inch or two away from the trim or surface you are going to paint up next to, this is much like taking a knife full of butter and spreading it across an entire slice of bread. After, spreading the paint over the section, go back and even the paint out evenly across the section and cut up next to the trim with the brush. You want to paint up next to the trim or surfaced to be cut-in with the paint brush after you have released most of the paint on the wall, it is easier to cut in with the tips of the brush exposed and not loaded with a lot of paint.
"Boxing" is a good method of mixing paints. Since paint is a mixture of solids and liquids, it is important that it be mixed thoroughly before using. To do this, the greater portion of the liquid contents of the can should be poured in a clean bucket somewhat larger than the paint can. Then, with a stiff paddle, the settled pigment in the original container should be loosened and any lumps broken up. After this, mix the material in the container thoroughly, using a figure 8 motion, and follow with a lifting and beating motion. Continue stirring the mixture vigorously while slowly adding the liquid that was previously poured off the top. Complete the mixing by pouring the paint back and forth from one container to the other several times until the entire amount is of uniform consistency.
A flat, semi-gloss, or high-gloss finish may be applied to the primed surface. For a flat finish, two coats of flat wall paint should follow the priming coat. For a semi-gloss finish, one coat of flat wall paint and one coat of semi-gloss paint should be applied to the primed surface. For a high-gloss finish, one coat of semi-gloss paint and one coat of high-gloss enamel should be used over the priming coat.
However, if you put a coat of pure white primer (which has a score of 0) on top of the brown color wall first, this immediately brings your luminosity score down to 4 (8 + 0 = 8/2 = 4, the average). This means you may only need one coat of yellow paint to give you the right hue and saturation. In reality of course, you will always want to do at least 2 coats. But even with a total of 3 coats (primer and paint) you are way ahead of the paint-only option.