Football coloring pages to color

Published at Tuesday, 2 June 2020.

Composition Wallboard. Composition wallboard usually presents no particular painting difficulties if the ordinary precautions are observed, such as making certain that the surface is dry and free from grease and oil. The painting procedure for wallboard is the same as for plaster; it requires a priming and sealing coat followed by whatever finishes coats are desired, or may be given one-coat flat or resin-emulsion type paint. When choosing colours for exterior surfaces, consider the style of the brickwork or masonry of your home along with the colours used on nearby buildings, so as to pick colours that are sympathetic to these surroundings. Colours for fences and sheds should be selected with the same criteria in mind. Cold water paints of the casein type may be applied either directly to a plastered surface, or the surface may be first given a coat of primer-sealer to equalize uneven suction effects. The same is true of resin-emulsion paints, with the recommendations of the manufacturer of the product being given preference in case of doubt. Since resin-emulsion paints usually contain some oil in the binder, they should ordinarily be applied only to plaster which has dried thoroughly.

EXTERIOR PAINTING. In buying paints that you are going to use for your exterior house, you have to pick a brand that has essential characteristics: hiding power, color retention, chalk-resistance, and blister resistance. Try before you buy Colour cards are fine for making an initial selection but you will want to see a true paint sample in situ before committing. Tester pots vary in price from £1 to £4. Paint onto a sheet of paper that you can move around the room to enable you to see the colour in different light conditions. The effect varies greatly. The window wall can seem dark while the wall opposite will be flooded with light. And of course there is a dramatic difference between natural and artificial light. Finally paint a patch directly onto the wall to gauge the colour, coverage and the final finish. Knock down texture is basically a orange peel that is sprayed on and allowed to "set-up" for a minute or two then gently "knocked down" by running a 6" drywall knife over it, "knocking down" the surface of the texture. Although knock down is a flattened version of orange peel, I suggest you do not use a spray can of orange peel, the knock down comes in its own spray can and the results are much better, again experiment before spraying it on the wall. However, If ever you apply any of the textures to the wall and are not satisfied with the results, wash the texture off immediately before it dries, then allow the wall to dry and try it again. Once you have the texture applied to your liking and you have allowed it to dry, you may want to paint the patches a couple of time before painting the entire wall, especially for walls where the paint to be applied will have some sheen. Multiple coats on these areas will make them blend in, unnoticeable, with the rest of the wall. You will know if the patches need more coats of paint, because the patch/texture will have absorbed the paint causing the spot to look duller than the rest of the existing wall. Technical advancements are constantly being made to improve the life span, durability, wear and performance of exterior paints. The Akrylatfarg range at Ray Munn, for example, is an environmentally sound water-based option.

Leave a Reply