Free coloring pages for word walls

Published at Monday, 1 June 2020.

Stripping all the chrome. One of the single most important steps in saving money on a paint job is to strip your Mustang as much as possible yourself. This means taking off anything and everything that won't be painted. The more you take off the less the painter has to mask around. Masking not only takes their time (which costs you money) but it also results in areas that simply can't get a full coat of paint. If you take everything off, then the painters can simply scuff and spray, which will give you better and more consistent coverage. Paint should not be applied to a concrete basement floor until the concrete has aged for at least a year. The floor should be dry when painted, the best time for application being during the winter or early spring (assuming there is some heating apparatus in the basement), when the humidity in the basement is low. In general, three coats of paint are required on an unpainted floor, and the first coat should be thin to secure good penetration. After the paint is dry, it should be protected with a coat of floor wax. Composition Wallboard. Composition wallboard usually presents no particular painting difficulties if the ordinary precautions are observed, such as making certain that the surface is dry and free from grease and oil. The painting procedure for wallboard is the same as for plaster; it requires a priming and sealing coat followed by whatever finishes coats are desired, or may be given one-coat flat or resin-emulsion type paint.

Scuff for paint. Once your Mustang is totally stripped of exterior chrome it's time to scuff up the existing paint. The paint shop should do this also, but on the lower end paint packages they won't spend much time here. It's better for you to do it so you know it's done thoroughly. By licensing these names, paint companies and retailers are taking advantage of the popularity of these well-known brands to attract you to these paints; that way they don't have to use obnoxious colors to bring your attention to their color wheel. If you look at the colors in these displays you will notice that they are generally missing those bright, saturated tones. Instead, most of the colors are more neutralized. Naturally, these colors are much more attractive to paint on a wall in your home. The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it. A large whitewash brush is best for applying the wash. One should not attempt to brush out the coating, as in applying oil paint, but simply spread the whitewash on as evenly and quickly as possible.

Leave a Reply