If you have a vinyl top then remove the molding separating the vinyl and paint. Drip rail chrome really should be removed also, but can be extremely hard to take off undamaged. If you plan on buying all new drip molding then definitely remove the old for painting. But if you want to keep the originals then it might be better to leave them on and let the painter mask around. If you have hub caps it's easy to just take them off. While the paint shop should completely mask all four tires, overspray can still find its way in. It's sometimes better to play it safe and just remove wheel covers. When choosing colours for exterior surfaces, consider the style of the brickwork or masonry of your home along with the colours used on nearby buildings, so as to pick colours that are sympathetic to these surroundings. Colours for fences and sheds should be selected with the same criteria in mind. To balance color, you must grasp the interconnectedness of color schemes. All color interactions are defined in the color wheel, and it has been used to build color schemes for centuries.
Water-thinned rubber-latex paint is already an old reliable, though it is only about 10 years old. It accounts for a big percentage of all paint sold and is still the most widely available of the easy-to-use finishes. One new type is a combination vinyl-rubber paint that is said to do a better job on interiors than either vinyl or rubber alone because it dries faster, lasts longer and has less sheen. The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it. Airless Tip: If you have somebody who can start masking off the trim, have them start on that while you convert the airless to a new color. When changing colors with an airless paint sprayer it is a good idea to have a second bucket filled half way with clean water. Place the intake hose in the clean water gently without getting the old color everywhere in the water. Take the tip out of the airless and spray all of the old paint out of the hose and back into its original paint bucket. Be careful when doing this that you recognize when the paint starts turning watery. When it does point the gun into the first bucket and spray until it looks pretty clean. It doesn't need to be perfectly clean. When it looks good, clean off the intake line in the clean bucket and get the old color off the intake line. Now place the intake line inside of your new trim paint. Colors that are equally removed from a reference color are triadic colors. Since these color schemes can become too intense, unless they are very toned down, they are very problematic to manage. This color combination works well in a child's room, and it can be used effectively in a kitchen.