Note: How to use an airless paint sprayer. I'm sure the guy at the rental store showed you how to use the airless (typically with his limited experience of actually painting a house), so hopefully I can offer you a couple new ideas on how to paint your home using an airless paint sprayer. When you first get the airless home, set it in the middle of the area that you would like to start painting. Typically the length of the hose is around 50'. Stretch out the hose prior to painting so that you don't have to worry about unraveling it while you are painting on a ladder. It is a good idea to have a 100' extension cord so that you can bring the airless anywhere you wish to paint without any restrictions. Tip: before you plug in the airless into the extension cord, MAKE SURE THE AIRLESS IS OFF! You don't want the airless to start pumping without paint! Now, when you go to set up the airless, before you turn it on, it's a good rule of thumb to have a second empty bucket next to your bucket of paint. I'll explain why in a second. Place both buckets side by side and place the intake hose (with the wire mesh filter end) into your 5 gallon bucket of paint while the primer hose (usually a lot smaller, about the size of a pencil'ish) is placed in the empty bucket of paint. Before you turn on the machine make sure that the airless is set to prime the machine first. There is a primer valve that you can rotate between prime and paint. A good way to see if the valve is set to prime or paint is to try this little test prior to turning the machine on. While turning the valve clockwise a couple times you will notice that the valve handle will separate from the machine in one position (leaving a slight crack between the valve and machine) while the other position the valve is close to the machine. The position in which the valve is separated from the machine is considered the primer position. Do this multiple times to see what I'm talking about. Don't worry if you keep on spinning the valve, you can spin it a million times in one direction and it won't hurt it.
Matt - Describes paints that give a flat, non-reflective finish. It is ideal for walls and ceilings that are not perfectly smooth.
Special Surfaces. WHITEWASH. Whitewashes and lime paints must be thin when applied. In fact, best results will be obtained if the application is so thin that the surface to which it is applied may easily be seen through the film while it is wet. The coating will dry opaque, but two thin Coats will give better results than one thick coat.
CONCLUSION. Once again go through the images and the story of the painting. Was your first impression different from what you see now? Take a 5-minute online test to explore your preferences in fine arts. In 5 minutes you will confidently say "I prefer impressionist cityscapes", or "This room calls for a color field painting", "I need to have an art nouveau nude in my bedroom" - and you will know what you are talking about!
Take your time there is no rush. There is nothing wrong with having your project take a couple of weeks.
A flat, semi-gloss, or high-gloss finish may be applied to the primed surface. For a flat finish, two coats of flat wall paint should follow the priming coat. For a semi-gloss finish, one coat of flat wall paint and one coat of semi-gloss paint should be applied to the primed surface. For a high-gloss finish, one coat of semi-gloss paint and one coat of high-gloss enamel should be used over the priming coat.
The stencil must be held very firmly against the surface with one hand, and the stencil brush worked over it quickly with the other hand. Or, if you have an assistant, it is best for one person to keep the stencil steady, while the other does the painting. In removing the stencil, make sure you pick it up without smudging.