WALL PAINTING TIPS. · Paint around the trim first, including edging around the ceiling. · When painting with a gloss finish, make the final brush strokes away from the light source of the room. The tiny ridges that a brush leaves won't be as pronounced. Use the same "wet to dry" method of painting.
The term paint is used to include paints, varnishes, enamels, shellacs, lacquers, and stains. • Paints are composed of mineral pigments, organic vehicles, and a variety of thinners all combined. • Varnishes are resins dissolved in organic thinners. • Enamels are pigmented varnishes. • Shellac is lac gum dissolved in alcohol. • Lacquers may be both pigmented or clear - the liquid portion usually is treated nitrocellulose dissolve in thinners. • Stains may be pigmented oil or a penetrating type. Many of these materials, such as paints, varnishes, and lacquers, are formulated for specific purposes: • Outside house paints and exterior varnishes are intended to give good service when exposed to weathering • Interior wall paints are formulated to give excellent coverage and good wash-ability. • Floor enamels are made to withstand abrasion. • Lacquers are formulated for rapid drying. • There are also formulas which provide extra self-cleaning, fume- resisting, waterproofing, hardening, flexibility, mildew-resisting, resistance to fading, and breathing qualities.
Before you start painting, it is a good idea to keep an eye on the weather for rain or snow. You don't want to start painting only to stop abruptly because of the weather.
When choosing colours for exterior surfaces, consider the style of the brickwork or masonry of your home along with the colours used on nearby buildings, so as to pick colours that are sympathetic to these surroundings. Colours for fences and sheds should be selected with the same criteria in mind.
Once the drywall compound/spackle has had sufficient time to dry, you will need to lightly sand the surface of the repair to smooth out any ridges that may have been caused while "coating" the patch. Once you have the surface sanded smooth, take a wet sponge or cloth and, by lightly washing/rubbing, blend the outside edge of the drywall compound/spackle back into the wall. For a smaller repair, you can wash away the excess drywall compound, leaving only the compound/spackle only in the area where the indent was filled. For a larger hole, after filling, sanding and using a wet sponge to blend the outside edge of the compound back into the wall, it may be necessary to texture the area in order to give the smooth patch the appearance of the existing wall.
Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M.
Some manufacturers recommend their vinyl paints for interior as well as exterior use; others say no, not so good. There are vinyls made specifically for interiors.