Masonry Walls and Ceilings. Interior masonry walls and ceilings above grade may, in general, be painted in much the same manner as plaster surfaces. Here again, it is necessary to allow adequate time for the masonry to dry before applying paint and, in addition, attention should be given to the preparation of the surface. When decorating a wall containing Portland cement (concrete, for example), it is essential to take precautions against the attack of alkali. For this purpose, alkali-resistant primers such as rubber-base paints may be used when oil paints are to follow. Plastic sheathing and masking tape was not available at the end of the painting project for whatever reason, I have no idea, but you have a Paint Brush that if not cared for will eventually dry up. Last solution that works well, is to take a sopping wet rag, wrapping the Paint Brush up like that burrito you missed wrapping up earlier. This will buy you some time until either you use the paint brush again, or you can properly clean it. Most of us look to save where we can, especially in this day and economic conditions. House painting is no different, when it comes to saving money. A home exterior weathers from harsh elements of heat, cold, sun, and snow, and exterior paint ages over time needing repainting. Exterior trim, being that of solid wood is normally the first to show signs of painting maintenance. Many times a homeowner happens to call, asking for only painting the trim. Trim paint jobs sound good at first, but have some underlying thoughts may have not been considered. Below are things to consider when considering painting trim only.
Matt - Describes paints that give a flat, non-reflective finish. It is ideal for walls and ceilings that are not perfectly smooth. The lite version of Galkyd is simply thinner. I use it more than the other. I love it. Paintings I did 16 years ago using Galkyds look as pristine as the day I painted them. You'll also need a canvas and some paint. I buy a tube of red, green, blue, purple, yellow, brown, white and black. I prefer what's called Ivory Black and a soft mixing white as you'll add white to a lot of different colors to make lighter versions. From these basic colors you can make any exotic color by mixing them in combination's. Be creative and experiment. And don't be afraid of color, because color is the most popular in museums! The bright paintings are historically the crowd favorites. As for color variety from these basic colors, mix red and white to make pink, mix yellow with green to make lime green, white with blue to make light blue, white with black to make gray, etc. Use your common sense and play with it! You'll also need pencils, an eraser and some Turpentine or Turpentine substitute. Keep your brushes soaking in it in a plastic cup to keep them clean and ready for your next color choice.... and to keep them from drying out. Valspar Paint, for instance, also produces paint branded as Laura Ashley, Eddie Bauer, Waverly, and more. These separate lines, or collections, have their own color wheel displays and are usually available wherever the primary brand, Valspar in this case, are sold. Other examples are Disney Paints, currently produced by Behr, and Ralph Lauren and Martha Stewart, formerly produced by Sherwin Williams. Cold water paints of the casein type may be applied either directly to a plastered surface, or the surface may be first given a coat of primer-sealer to equalize uneven suction effects. The same is true of resin-emulsion paints, with the recommendations of the manufacturer of the product being given preference in case of doubt. Since resin-emulsion paints usually contain some oil in the binder, they should ordinarily be applied only to plaster which has dried thoroughly.