Scuff for paint. Once your Mustang is totally stripped of exterior chrome it's time to scuff up the existing paint. The paint shop should do this also, but on the lower end paint packages they won't spend much time here. It's better for you to do it so you know it's done thoroughly. You'll need a large compressor, not just the typical 20 gallon variety most of us have. This is a 60 gallon, vertical compressor with typically a 5+ hp motor. Then you'll need a decent paint gun (possibly 2; one for primer and one for color) which again is an expense. Then there's the question of where you'll paint the car. Renting a paint booth is best, but can be expensive and hard to find. You can always seal up your garage or shoot out in the wetted down driveway, but you'll inevitably get dirt and moisture into the paint. Painting trim is normally done by roller and brush, not sprayed, so more manual labor is required painting trim, and most cases costing 60% of the total exterior painting job.
Step three: go online and study the basics of shadow and light. It's a visual thing, and too complicated to talk about here. But once you see it, it'll come to you quickly. Simply Google "shadow and light in painting" and the basics will come up. Once you know these rules, you can apply it to any shape, any form, any painting. And it'll make you keenly aware of shadow and light on virtually any object on earth. It's what makes a painting three- dimensional and expensive looking. You can also buy art books on shadow and light at any bookstore. But make sure you sit down for a couple of hours and study it. It will come quickly to you, I promise. Suppose it rains while you're working? Vinyl paint dries fast - as quickly as 10 to 30 minutes - and will withstand a shower after that time. It takes another 12 hours to "cure," by then forming an exceptionally tough, long-lasting film that stands up well against weather, sun, salt air and factory smoke. Practically every manufacturer has a "color system," a fat book of color chips with instructions for duplicating each chip. This is accomplished by intermixing cans of colored paint, by adding a concentrated color to a can of white or colored paint, or by adding concentrated color or colors to a can of neutral "base" paint. And for those who don't want any guesswork there's the Color Carousel that mixes the paints right in the store. Whatever the method, the result is a range of colors such as no amateur painter has seen. For stippling you need a special brush; get one that is flat, and has short, stiff bristles.