Preparation, the key to a successful paint job is to take the correct steps when preparing the job. Preparation for this article, has two parts, the first part is wall prep. The walls you are going to paint may have nail holes or imperfections that need to be filled before you paint. The proper way to fill them, if they are smaller is with water putty, by simply forcing a little bit of the putty in the hole and breaking it off flush with the surface. For larger depressions, use a drywall compound or spackle, which may require a second application to fully fill the indentation and make the repair/"patch" flush with the wall. Will the color look harsh on me? If you choose a hair color that is natural looking, it will not look harsh on you. For example: If you are young, and want to enhance your own hair color. Your stylist will choose a color very similar to what you already have. Younger people can get away with more drastic changes in their hair color because they generally have vibrant skin tones. Although, if a young person chooses a black color for instance, and their hair color is not naturally black, this can sometimes be very harsh looking on them also. Like wise, when young people with very dark hair, try to go all over blonde, it can be a too harsh for the same reasons. And, its never been more important to know your colors. Why? Because color is back in a big way! Just look at the vast variety of colors in the department stores.
The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it. Anti-condensation paints are used for rooms with humid conditions such as kitchen and bathrooms. This paint is usually formulated to prevent condensation and often includes fungicide. Intensity refers to a colors brightness or saturation. Intensity refers to how pure a color is. For instance, if you were to use cadmium red straight from the tube, it would have a high intensity. If you were to mix it with another color however, its intensity would be diminished. Alkyd is an old interior paint made newly popular by a change in solvent - a super-refined petroleum chemical that has almost no odor. It is not a water paint. You thin it and clean brushes with mineral spirits or turpentine, or, if you want to retain the odorless feature, with the new odorless solvent. (Ask the paint-store man for just that, odorless solvent).