You scuff up existing paint for two reasons. First, you want to get rid of any oil, grease or dirt trapped in the top layer of paint. This is the stuff that cleaners and degreasers can't get off. The second reason to scuff is to set up a physical bond for the new primer and paint to adhere to. You want to give the old paint some tooth so the new sticks better.
Paying for a Brand Name Paint Color? If you are worried about ending up with an ugly paint color, you may be somewhat safer utilizing one of these designer collections. However, the color range offered by any one of these alternative brands is very limited and typically the whole line of hues is all neutralized to about the same tone. This gives the smaller brand a nice consistent look, but it doesn't allow for much variety. Also, these signature paints are typically more expensive (often 50% more) despite the fact that you can get very similar colors from the primary "mother" brand for considerably less money.
Following a European directive, the British paint industry has reduced VOCs in two stages, the second of which came into force in January last year.
Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M.
Acrylic is the second new name for magic in paints. This is also a plastic-in-water. Solid acrylic you know as the beautiful, glasslike Plexiglas and Lucite.
"Boxing" is a good method of mixing paints. Since paint is a mixture of solids and liquids, it is important that it be mixed thoroughly before using. To do this, the greater portion of the liquid contents of the can should be poured in a clean bucket somewhat larger than the paint can. Then, with a stiff paddle, the settled pigment in the original container should be loosened and any lumps broken up. After this, mix the material in the container thoroughly, using a figure 8 motion, and follow with a lifting and beating motion. Continue stirring the mixture vigorously while slowly adding the liquid that was previously poured off the top. Complete the mixing by pouring the paint back and forth from one container to the other several times until the entire amount is of uniform consistency.
Traditional Paints. Available from specialists such as Farrow & Ball and The Real Paint & Varnish Company, lime wash and distemper paints can be useful for restoration projects, although some of the contents are potentially hazardous and can irritate eyes and skin. Use the modern equivalents where possible, as these are usually safer and more effective.